Wide Compatibility: Compatible with ST-5600/ST-5601/ST-6600 with model specific design for proper fit
Comfortable Hand Grip: Soft and comfortable hand grip that can absorb vibration and reduce hand fatigue during long-term riding
High-Quality Silicone Material: Made of high-quality silicone material that is soft and durable for extended use
Anti-Slip Design: The non-slip stripe surface provides better hand grip for enhanced performance and control
Easy Installation: Simple and straightforward installation process allows you to quickly replace your worn brake lever hoods
Unhappy Customer (comprador verificado) –
Good Value and Great Fit for ST-6600
The product fit perfectly. I was thrilled with the look and feel. I bike 15 miles a day so I put these to the test. Here is a note on the installation. You only need to loosen the shift cable of the grip you are replacing. You don’t need to touch the brake cable. You pull the cable out up to the upper cable stay. There is no need to remove the cable cover above the upper stay and you do not need to remove the cable from the shifter. The cable covers are very flexible and can be stretched over the shifter and then threaded over the shift cable that is hanging down. To install the new cover I used hand sanitizer to make it slip on easier. Be patient and it will slip on and fit nicely.
Ashley (comprador verificado) –
As expected
Fit them on my ST-5600s. They fit just fine. They don’t have any texture whatsoever, unlike the originals, but I suspected that would be the case as these were the cheapest available at the time.
Tharun Prakasam (comprador verificado) –
Worth the money
Fits perfectly
scmrak (comprador verificado) –
Perfect fit
After 30K miles and a couple of handstands, one of my hoods had rotted away. I bought these as a replacement for my Ultegra 6600 shifters. The fit is spot on.Some hints for potential buyers: Shimano stamps the model number on the base of the shifter (at the handlebars, under the trailing edge of the hood). Check the model number before ordering; these are NOT compatible with other models not listed by the maker. Getting them on requires that you either remove the shift cable or take the shifter off the bike and remove the brake cable. The fit is VERY tight, but soaking the hoods in hot water will allow them to stretch a little. Have funt!
James G (comprador verificado) –
Great update for Shimano 6600 shifters
A great option to update a couple of old-ish bikes. Perfect fit for Shimano 6600 shifters. I recommend slathering the shifter with hand sanitizer to help get it on. You have to get a little tough with them to get into place, but these are flexible enough to do the job. Good fit, look factory.
Doctor Dave (comprador verificado) –
Very comfortable
I had to replace my old hoods due to the rubber breaking down and becoming a sticky mess. This was the first time I had done this job, and it wasn’t that tough. the hoods slipped on easily. The material is silicone which is different than the original rubber. I like these more. They appear to be durable and hopefully they last a long time.
Russell Reid (comprador verificado) –
These worked really well on my Shimano SS-6603 levers, should fit all 6600 series levers
It’s great that these are available. These fit my older Shimano levers, survived installation without tearing, are a huge upgrade to the old sticky brake hoods. Happy that they are still available!!
pj (comprador verificado) –
Good fit for ST6600
Fits nicely on my ST6600. It has a perfect thicknes and grip.
Gray 4 Wisdom (comprador verificado) –
Great replacement for original hoods..
Works great. The buttons for my flight deck computer also work perfectly.